More ideas from Csiró
Tool Position Setting Part 3. - MACH3 témájú cikkek <!--if(Cikkek)-->- Cikkek<!--endif--> - Cikkek katalógusa - Hobby , 3D, Relief, CNC, fafaragás

Tool Position Setting Part 3. - MACH3 témájú cikkek <!--if(Cikkek)-->- Cikkek<!--endif--> - Cikkek katalógusa - Hobby , 3D, Relief, CNC, fafaragás

Endmill feeds and speeds

CNC Machining Speeds and Feeds, Feed Rate, Chip Load per Tooth (CLPT), Removal Rate, or Power Requirement.

CNC Pen Lift

CNC Pen Lift

CoreXY CNC Plotter: 16 Steps (with Pictures)

This instructable describes an plotter made from low cost aluminium extrusion, a piece of particle board, two stepper motors, and a few belts and.

Sphere Cutting Jig

Sphere Cutting Jig - Homemade sphere cutting jig intended for utilization with a woodturning lathe. Constructed from aluminum, hex stock, and hardware.

Nema23 Stepper Motor Kit 3.1Nm x 3 Axis + 3 Mounts, Motors for CNC router project

Stepper Motor Kit x 3 Axis + 3 Mounts, Motors for CNC router project