Tibor Lakatos
További ötletek tőle: Tibor
Welding Table- Retractable wheels and receiver up top for tools! Brilliant!

Welding Table- Retractable wheels and receiver up top for tools! Brilliant!

Retractable wheels: Hydraulic jack pushes crosspiece down/table up compressing the springs between crosspieces at wheel locations

Retractable wheels: Hydraulic jack pushes crosspiece down/table up compressing the springs between crosspieces at wheel locations

Retractable swivewling casters

Retractable swivewling casters

Graphic Equalizer with 5-Band Capability | DIY Electronics Projects

Graphic Equalizer with 5-Band Capability | DIY Electronics Projects

Giga Bass for Bass Boost Circuit PCB

Giga Bass for Bass Boost Circuit PCB

#CNC G Code (1 of 2 CNC G & M codes infographics.)

#CNC G Code (1 of 2 CNC G & M codes infographics.)

Picture of Circuit diagram NE555 PWM led dimmer

Picture of Circuit diagram NE555 PWM led dimmer

PWM LED Dimmer Using NE555 Circuit Diagram Get complete information about this circuit at http://www.electronicshub.org/pwm-led-dimmer-using-ne555/

PWM LED Dimmer Using NE555 Circuit Diagram Get complete information about this circuit at http://www.electronicshub.org/pwm-led-dimmer-using-ne555/

Create an Arduino based soldering station for a standard JBC soldering iron.

Create an Arduino based soldering station for a standard JBC soldering iron.

Drill Sharpening Jig by th62 -- This is a drill sharpening jig I made some time ago and the grinder setup I use it on.   The grinder is just an el cheapo, I've been meaning to change the grinder as the wheels wobble all over the place.   One day I may even get around to replacing it. Anyway some details on both. The Jig: I used a piece of 25mm square bar, linished it, milled a V for the drill, cut a 2mm slot down the centre for 110mm, drilled a stepped hole through: 5mm for 30mm and then...

Drill Sharpening Jig by th62 -- This is a drill sharpening jig I made some time ago and the grinder setup I use it on. The grinder is just an el cheapo, I've been meaning to change the grinder as the wheels wobble all over the place. One day I may even get around to replacing it. Anyway some details on both. The Jig: I used a piece of 25mm square bar, linished it, milled a V for the drill, cut a 2mm slot down the centre for 110mm, drilled a stepped hole through: 5mm for 30mm and then...