Nemetferi
További ötletek tőle: Nemetferi
Tricked out Black & Decker Workmate and Bench Bull Accessory - YouTube

Tricked out Black & Decker Workmate and Bench Bull Accessory - YouTube

Snap-On Soft Jaws I’ve been using an old metal-working vise in my shop for years. Occasionally I really do need a metal-working vise, but most often I use it to hold drawer sides up high when cutting dovetails. Unfortunately the metal jaws can be a hazard to edge tools and they can mar the surface of the wood. I solved these problems by adding a pair of soft jaws to …

Snap-On Soft Jaws I’ve been using an old metal-working vise in my shop for years. Occasionally I really do need a metal-working vise, but most often I use it to hold drawer sides up high when cutting dovetails. Unfortunately the metal jaws can be a hazard to edge tools and they can mar the surface of the wood. I solved these problems by adding a pair of soft jaws to …

clamping-bench-dog-prensa-horizontal.jpg-14760d1478028058 (800×544)

clamping-bench-dog-prensa-horizontal.jpg-14760d1478028058 (800×544)

clamping-bench-dog-prensa-horizontal.jpg-14760d1478028058 (800×544)

clamping-bench-dog-prensa-horizontal.jpg-14760d1478028058 (800×544)

Szorítópad kutya-dsc04601.jpg

Szorítópad kutya-dsc04601.jpg

Belt Sander - Edge Sanding Platform - by steliart @ LumberJocks.com ~ woodworking community

Belt Sander - Edge Sanding Platform - by steliart @ LumberJocks.com ~ woodworking community

Lathe Sanding Drum | Woodsmith Plans

Lathe Sanding Drum | Woodsmith Plans

Small Parts Clamp (Softer grip than pliers.) The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together. Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.

Small Parts Clamp (Softer grip than pliers.) The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together. Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.

Miniprojekt: Trommelschleifer Bauanleitung zum selber bauen

Miniprojekt: Trommelschleifer Bauanleitung zum selber bauen

Cheap Sharpening kit, and a great use for all those guitar picks I fish out of washer and dryer...

Cheap Sharpening kit, and a great use for all those guitar picks I fish out of washer and dryer...