Balog Norbert
További ötletek tőle: Balog
How to connect Arduino Due TinyG2 (g2core) with TB6600 stepper motor driver

How to connect Arduino Due TinyG2 (g2core) with TB6600 stepper motor driver

$2000 Quality Prints From a $200 Printer : an Upgrade Guide for the Anet A8 3D Printer: 19 Steps (with Pictures)

$2000 Quality Prints From a $200 Printer : an Upgrade Guide for the Anet A8 3D Printer: 19 Steps (with Pictures)

Anet+A8+Y+Belt+Tensioner+by+Audiogod.

Anet+A8+Y+Belt+Tensioner+by+Audiogod.

Attention! If using Cura make sure to uncheck the option "Scale large objects" found in Settings>General>Opening>Scale large objects or rescale the object to 100%. Failure to do so will result in a piece that won't fit. I really liked the design of http://www.thingiverse.com/thing:2069466 by 3r4th. Remixed with a hexagon shape to match my board enclosure and keep my look consistent. I have not printed yet but should be just as good as the original by 3r4...

Attention! If using Cura make sure to uncheck the option "Scale large objects" found in Settings>General>Opening>Scale large objects or rescale the object to 100%. Failure to do so will result in a piece that won't fit. I really liked the design of http://www.thingiverse.com/thing:2069466 by 3r4th. Remixed with a hexagon shape to match my board enclosure and keep my look consistent. I have not printed yet but should be just as good as the original by 3r4...

MOSFET wiring on Anet A8

MOSFET wiring on Anet A8

RFID + arduino tutorial

RFID + arduino tutorial

Spirograph

Spirograph

This perfect marking tool straddles your board to mark a perfectly centered line, or you can use the notches to mark offset lines from 1/16'' to 1/2'' from the edge in 1/16'' increments.

This perfect marking tool straddles your board to mark a perfectly centered line, or you can use the notches to mark offset lines from 1/16'' to 1/2'' from the edge in 1/16'' increments.